double crank mechanism
英 [ˈdʌbl kræŋk ˈmekənɪzəm]
美 [ˈdʌbl kræŋk ˈmekənɪzəm]
网络 双曲柄机构
双语例句
- Analysis of the Characteristic of Quick-Return of Offset Double Crank Slider Mechanism
偏置双曲柄滑块机构急回特性分析 - Study of the Sufficient and Necessary Conditions for Existence of Double Crank of Planar Five-Bar Mechanism
平面五杆机构双曲柄存在的充要条件研究 - A New Design Method of Double Crank Mechanism
双曲柄机构设计新方法 - Principles of double crank mechanism
双曲柄机构原理 - The mechanism offset double crank slider not only has the characteristic of super quick-return ( k>3), but also has variety time ratio. The time ratio of this mechanism is changed only the setting position is changed, when the sizes of all linker are determined.
偏置双曲柄滑块机构不仅具有k>3的超急回运动特性，而且具有可变急回运动特性，机构中各构件尺寸一定时，仅仅改变其相对安装位置，便可获得不同的行程速比系数。 - Because the study of double crank four ring-plate-type cycloid drive is still on the beginning, to analyze the reliability mechanism, to exclude the irresponsible major factor and to prevent the incidence rate of dangerous accident.
由于双曲柄环板式针摆行星减速器尚处于研究阶段，因此对其进行可靠性研究有着重要的意义。 - The characteristic of quick-return of offset double crank slider mechanism was analyzed in this paper. The synthesis method and curve of this mechanism with minimum transmission angle were presented.
本文分析偏置双曲柄滑块机构的急回运动特性，给出了按最小传动角设计偏置双曲柄滑块机构的设计方法和设计曲线。 - Optimized of parameters of basic dimensions of double crank shaft mechanism
双曲柄机构基本尺寸参数的优化 - Three-Ring Drive takes parallel three phase double crank mechanism as input mechanism, which has redundant restraints and belongs to statically indeterminate structure.
三环传动采用三相并联双曲柄机构作为输入机构，具有虚约束，在静力学上属于超静定系统。 - Modeling and optimization of double crank slide block steering mechanism
双曲柄滑块式转向机构的建模及优化研究